Briggs and Stratton P2200 Inverter Generator review

You should know thatBefore starting this Briggs and Stratton P2200 Inverter Generator review we test a few other inverters as well. Including Westinghouse WH2200iXLT, Generac 7117 Gp2200I, and Pulsar G2319N.

The P2200 from Briggs and Stratton’s Power Smart Series is an inverter generator paired with the in-house developed Quiet Power Technology and parallel capability. The Briggs and Stratton P2200 is an inverter generator, which refers to its ability to throttle its engine. This allows it to consume less fuel making its operating cost economical for the average user.

The industry-changing Quiet Power Technology ensures that the generator produces little to no noise. This is especially in the case when it is operating at a relatively high load site. Following through, it will produce large amounts of power compared to its normal regular use. The included 111 cc engine produces a start of about 2200 watts.

Briggs and Stratton P2200 Power Smart Series Inverter Generator

For continuous running, the inverter generator produces a steady 1700 wattage power supply. It is readily available to use when required. Consumer electronics can be charged safely using this generator. This is possible because of its super-low tone muffler. It is set for regular usage and recoil for when the generator is started up.

The proprietary Quiet Power Technology guarantees lower than 3 % harmonic distortion. It allows for the safe charging of portable electronic devices. Moreover, you can use the onboard-provided USB and connection ports. Considering its operation time is up to 8 hours while running at 25 % load per gallon, its performance per dollar is excellent.

Moreover, this Briggs & Stratton P2200 Power Smart Series Inverter Generator includes:

  • One 12V-5A, DC Outlet along with USB Adapter
  • Two 120V Household Outlets
  • One Parallel Port
  • Two years Limited Consumer Warranty

Find more info about this Briggs and Stratton P2200 Power Smart Series Inverter Generator in the Additional information’s Specification section.

This remarkable feature is mostly due to inverter technology. It enables the generator to be more efficient and consume less fuel when less power is required. This will help produce more power when the situation changes accordingly. The attached parallel connector port is the result of perfect integration between the generator and the load. You will get to set a connection between 2 units for more power.

The total decibels produced by the generator operating at 25 % load are about 59. Compared to a normal human conversation, which is as loud as 70 decibels, the inverter generator is quieter than many human discussions.

Considering the multiple features provided by this inverter generator, this generator qualifies as the best inverter generator. This is based on a comparison with others in the same price range.

Briggs and Stratton P2200 key Features:

  • Running Watts: 1700 Watts
  • Surge Watts: 2200 Watts
  • Runtime: 8 hours
  • Tank Size: 1 gallon
  • Noise level: 59 dB at 25 % load

Briggs and Stratton P2200 Inverter Generator review Conclusion

Even though the low power output is not that evident, it can be easy to find another inverter generator within the same price range. This does not allow the product to compete on the same plane field in the market. Consumers, however, won’t be left disappointed with its features. Its efficient performance helps it stand out and be a worthy pick.

The fuel tank may be small, but it directly affects the portability of the generator itself. You can always opt for a bigger fuel tank if needed. It has been determined that gas efficiency greatly affects the fuel requirement too. So, if you were to choose a reputable fuel, you won’t be held back from operating at a higher load capacity for longer times.

Briggs and Stratton P2200 Quick Setup Guide

Before starting the Briggs and Stratton P2200 you must know this.  Hope this helpful guide can help you a lot.

Unpack the Generator

  • Set the carton on a rigid, flat surface.
  • Remove everything from the carton except the generator
  • Open carton completely by cutting each corner from top to bottom.

Add Engine Oil and Fuel

  • Move generator outdoors to a flat, level surface.
  • Loosen the two maintenance cover screws and remove the side maintenance cover.
  • Clean area around oil fills and remove yellow oil fill cap.
  • Using an oil funnel, slowly pour contents of a provided bottle of engine oil into the oil fill opening to the point of overflowing at the oil fill cap.
  • Replace oil fill cap and fully tighten.
  • Replace the maintenance cover and hand tighten the two maintenance cover screws.
  • Clean area around fuel fill cap, remove the cap.
  • Slowly add unleaded fuel to the red fuel level indicator in the fuel tank. Be careful not to fill above the indicator. This allows adequate space for fuel expansion.
  • Install fuel cap and let any spilled fuel evaporate before starting the engine.

The thing you must Notice

  • You must properly fill the engine with oil before attempting to start the generator.
  • Do not use unapproved gasoline such as E15 and E85.
  • Do not mix oil in gasoline or modify the engine to run on alternate fuels

Move Generator to Safe Operating Location

  • Move the generator outside to a flat, level surface, in an area that will not accumulate deadly exhaust gas. Engine exhaust contains carbon monoxide, a poisonous gas that could kill you in minutes. You CANNOT smell it, see it, or taste it. Operate ONLY outside far away from windows, doors, and vents. Install carbon monoxide alarms. DO NOT run this product inside homes or garages, even if using fans or opening doors and windows. Direct exhaust AWAY from windows, doors, and vents.
  • To reduce the risk of exhaust heat or exhaust gases igniting nearby combustible material, keep at least 5 feet (1.5 m) clearance on all sides of the generator, including overhead.

Start Generator

Briggs and Stratton P2200 Inverter Generator reviewBefore starting the Briggs and Stratton P2200 you must disconnect all electrical loads from the generator. Use the following start instructions.

  • Make sure the unit is on a level surface.
  • Turn the engine switch
  • Push choke lever to CHOKE position.
  • Grasp recoil handles and pulls slowly until slight resistance is felt. Then pull rapidly to start the engine.
  • If the engine starts proceed to the last step. If the engine fails to start, proceed to step 6.
  • Move choke lever to half choke position, and pull recoil handle twice. If the engine fails to start, repeat steps 3 thru 4.
  • Slowly move the choke lever to RUN position. If the engine falters, move the choke lever to half the choke position until the engine runs smoothly, and then to the RUN position.

Plugin Items to be Powered

  • Make sure the green output indicator light comes on. It may take up to 3 seconds
  • Let engines stabilize and warm up for a few min after starting
  • Plugin and turn on the desired 120 V, Single shape, 60 Hz electrical loads
  • If you overload the generator, the red LED overload alarm light comes on and cuts power to the receptacles. The green output indicator light will also go off. You must turn off and
    unplug all electrical loads, press the “Reset” button on the generator control panel and then plugin and restart electrical loads one at a time to continue in normal operating mode.
  • This 12 volt DC receptacle along with the USB adapter allows you to recharge any USB-powered device with a USB charging cable. This receptacle is protected by a push to reset the circuit breaker.

Shut Down Generator

  • Turn OFF and unplug all electrical loads from generator panel receptacles. NEVER start or stop the engine with electrical devices plugged in and turned ON.
  • Let the engine run at no-load for several minutes to stabilize the internal temperatures of the engine and generator.
  • Move engine switch to the OFF position.
  • To prepare for storage, refer to Operator’s Manual.

Get more information about Briggs and Stratton P2200 Power Smart Series Inverter Generator Or Buy from amazon.

  • Product
  • Specification
  • Deals

Briggs and Stratton P2200 Power Smart Series Inverter Generator

  • Running: 1700 Watts
  • Starting: 2200 Watts
  • Fuel: Dual Fuel
  • Capacity: 1 Gallon
  • Starting: Recoil Pull Start
  • RV Ready: Yes
  • Noise: -
  • Weight: 55 pounds
  • Runtime: 8 hours
  • Warranty: 24-Months Consumer
The Briggs and Stratton p2200 is an inverter generator from the company's PowerSmart series. The inverter generators in this series have a portable ...
Basic 10
Fuel Tank Capacity 1 Gallon
Fuel Type Dual Fuel
Run Time 8 hours
Running Watts 1700 Watts
RV Ready Yes
Start Type Recoil Pull Start
Starting Watts 2200 Watts
Unit Weight 55 pounds
Warranty 24-Months Consumer
Generator Features
Engine Briggs & Stratton OHV, 111cc
Volts 120
Fuel Gauge N/A
Hour Meter N/A
Handle Style H-Handle
Wheels N/A
Choke Type N/A
Product information
Model 30651
Part Number
Size (W)
Product Dimensions 22.4 x 14.4 x 19.9 inches
isbn 1220
Weight55 lbs
Dimensions22.4 × 14.4 × 19.9 in
9.4 Total Score
P2200 A perfect emergency generator.

A perfect RV Ready emergency generator that you should have one,

9Expert Score
9.8User's score
  • Ensures regular, efficient performances at low operating costs
  • The compact design makes it portable
  • Included USB ports are a useful extra, especially for those who go outdoor camping.
  • Low output power production
  • Small 1 gallon fuel tank
Add your review  |  Read reviews and comments

This is Alex Behind this BestGenerator.Review. I have completed my Diploma in Electrical & Advanced Electrical from Apex Technical School, NYC. The School curriculum covers an introduction to the National Electric Code and includes an emphasis on electrical safety, breakers and fuses, blueprints, grounding, outlets, splicing, and bonding. Besides my job, I like to spend my time testing and playing with different electrical devices. Generators are one of my favorite machines.

Show all Most Helpful Highest Rating Lowest Rating Add your review
  1. 4.9

    For about 15 minutes, the first one I got didn’t work at all. The overload breakers kept on tripping even though nothing was connected.

    When I called Amazon, they sent me a new one right away and took the broken one away for free.

    There is a new one that has probably been running for about 50 hours and is in great shape. I have a 3000 watt Yamaha inverter, and this generator isn’t as quiet as it is. It’s still not very noisy.

    I’d say it’s a good idea because it’s cheap and easy to move.

    + PROS: Great services
    - CONS: A little more noise than I thought.
    Helpful(1) Unhelpful(0)You have already voted this

    Leave a reply

    Your total score

    Best Generator Review